ManualsContentsPreviousNext |
This section describes how to register a Protection code to a single user.
Press the [User Tools / Counter] key.
Press [System Settings].
Press [Administrator Tools].
Press [Address Book Management].
Check that [Program / Change] is selected.
Select the name whose protection code you want to register.
You can search by the registered name, fax number, folder name, e-mail address, or IP-Fax destination.
Press [Protection].
Press [Destination] or [Sender] under "Use Name as".
Both [Destination] and [Sender] can be selected at the same time.
Press [Change] under "Protection Code".
Enter a protection code using the number keys, and then press the [] key.
Press [OK].
Press [Exit].
Press the [User Tools / Counter] key.
Specify a protection code of up to eight digits. You can also specify "Protection" without specifying a protection code.
To change the protection code settings, repeat step 3 to 11.