visable.png

Skip headerimage
ManualsContentsPreviousNextHelp

Top Page > Network and System Settings Guide > Connecting the Machine > Connecting to the Interface > Connecting to the Ethernet Interface

Connecting to the Ethernet Interface

This section describes how to connect an Ethernet cable to the Ethernet interface.

Important

  1. Make a loop 3 cm (1.2 inches) from the end of the Ethernet cable and attach the included ferrite core to the loops as shown.

    illustration of Ethernet cable with ferrite core

  2. Make sure the main power is switched off.

  3. Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

    illustration of connecting the Ethernet interface cable

  4. Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

  5. Turn on the main power switch of the machine.

    10BASE-T/100BASE-TX port illustration (numbered callout illustration)

    1. Indicator (green)

      When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating it is turned off.

    2. Indicator (yellow)

      When 100BASE-TX is operating, the LED is lit yellow. When 10BASE-T is operating, it is turned off.

    Note

    • For details about how to turn on the main power switch, see "Turning On the Power", About This Machine.

    • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.

TopPreviousNext
Copyright (C) 2009