Use the “lpr” command to view and configure LPR settings.
View Setting
msh> lpr
Checking host name when deleting the job
msh> lpr chkhost {on|off}
The default is “on”.
If “on” is selected, you can delete print jobs only from the IP address of the host that sent the print job. If LPR is disabled, you can also delete print jobs sent from IP addresses other than that of the host.
Printer Error Detection Function
msh> lpr prnerrchk {on|off}
The default is “off”.
If you set this to “on”, the printer stops receiving data and will wait until the error is resolved before continuing processing a job.
