ManualsContentsPreviousNext |
The following items should be followed during use of this machine.
|
|
Do not turn the power off while the operation switch indicator is lit or blinking. Doing so may damage the hard disk.
Before unplugging the power cord or turning off the main power switch, make sure remaining memory space is at 100%, as shown on the screen. See "Turning On/Off the Power".
Do not touch areas on or around the fusing unit. These areas get hot.
After scanning originals continuously, the exposure glass may become warm - this is not a malfunction.
The area around the ventilation holes might feel warm. This is caused by exhaust air and is not a malfunction.
When you use this machine for a long time in a confined space without good ventilation, you may detect an odd smell. To keep the workplace comfortable, we recommend that you keep it well ventilated.
The area around the ventilation hole may become warm. This is caused by exhaust air and is not a malfunction.
If the machine is moved from a cold to a warm place, condensation may form inside it. After moving the machine, do not use it for at least an hour. The machine requires this time to adapt to its new environment.
The machine will malfunction if its internal temperature becomes too high. Be sure not to block the intake and exhaust vents.
Do not turn off the power while the machine is in operation. See "Turning On/Off the Power".
Do not open the covers of the machine when it is in operation. If you do, misfeeds might occur.
Do not move or tilt the machine when the power is on.
Do not allow small objects such as paper clips to fall into or become stuck inside the machine.
Do not knock the machine while it is operating (for instance, do not use the machine's surfaces to knock stacks of paper into square).
Depending on the ambient temperature and humidity, steam may come from the exhaust vent behind the control panel during printing. This is water vapor from the paper, not a sign of malfunction.
If condensation forms inside the machine as a result of temperature change, the machine may not print properly.
The anti-humidity heater and optional anti-condensation heater warm the machine's interior to prevent it becoming too humid. These heaters keep the machine warm even if the main power switch is turned off.
Be sure to make a note of the registered machine settings in case they are lost due to accident or malfunction.
The supplier shall not be liable for any loss or damage resulting from a failure of the machine, loss of settings, or use of the machine.