visable.png

Skip headerimage
ManualsContentsPreviousNextHelp

Programming Initial Set Up of a Special Sender

This section describes how to program Initial Set Up of a Special Sender.

Program the "Initial Set Up" of a Special Sender. You can also specify the Bypass Tray Paper Size.

  1. Press [Facsimile Features].

  2. Press [Reception Settings].

  3. Press [Program Special Sender].

  4. Press [Initial Set Up].

    Operation panel screen illustration

  5. Select the function you want to program.

    Operation panel screen illustration

  6. To program Authorized Reception and Special Reception Function, press [Authorized Reception] or [Special Reception Function].

  7. Press [On] or [Off], and then press [OK].

    The illustration shows the "Authorized Reception" display as an example.

    Operation panel screen illustration

  8. To program Bypass Tray Paper Size, press [Bypass Tray Paper Size].

    You can select a size from [Auto Detect], [Regular Size], or [Custom Size].

    If you select [Auto Detect], proceed to steps 9 and 14.

    If you select [Regular Size], proceed to steps 9, 10 and 14.

    If you select [Custom Size], proceed to steps 9 and 11 to 14.

  9. Select the size you want to program.

    Operation panel screen illustration

    If you select [Regular Size], select a paper size displayed, and then proceed to step 14.

    If you select [Custom Size], proceed to step 11.

  10. Select the size you want to program from the sizes shown.

  11. Make sure that [Vertical] is selected.

  12. Enter the vertical size of the paper using the number keys, and then press the [Sharp] key.

    Operation panel screen illustration

    Specify a vertical size from 100 mm (4.0") to 305 mm (12.0").

    Each time you press [mm] or [inch], the units switch between "mm" and "inch".

    If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).

  13. Enter the horizontal size of the paper using the number keys, and then press the [Sharp] key.

    Operation panel screen illustration

    Specify a horizontal size from 140 mm (5.5") to 600 mm (23.6").

    Each time you press [mm] or [inch], the units switch between "mm" and "inch".

    If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).

  14. Press [OK].

  15. Press [Exit].

  16. Press the [User Tools/Counter] key.

Note