This section describes how to make duplex copies.
Copies two 1-sided pages or one 2-sided page onto a 2-sided page.
You cannot use the bypass tray with this function.
The paper weight that can be used with this function is 64 - 128 g/m2 (17 - 34 lb. Bond).
1 Sided 
2 Sided
Copies two 1-sided pages on one 2-sided page.
2 Sided 2 Sided
Copies one 2-sided page on one 2-sided page.
Original orientation and completed copies
The resulting copy image will differ according to the orientation in which you place your originals (
or 
).
The table shows the orientation of images on the front and back of copies, not the orientation of delivery.
Press [Dup./Combine/Series].
Make sure that [Duplex] is selected. If [Duplex] is not selected, press [Duplex].
Select [1 Sided 2 Sided] or [2 Sided 2 Sided].
To change the original or copy orientation, press [Orientation].
Press [OK].
Place the originals, and then press the [Start] key.
When placing an original on the exposure glass, start with the first page to be copied. When placing originals in the ADF, set so that the first page is on the top.
You can also select [1 Sided 2 Sided] or [2 Sided 2 Sided] directly by pressing the copy function key. In that case, proceed to step 5.
When placing originals on the exposure glass, or in the ADF using Batch mode, press the [
] key after all the originals have been scanned.
You can specify the margins under Edit in User Tools. For details about Edit, see “Edit”.
You can use the following copy paper with this function:
A3, A4, A5, B4, B5, 11 × 17, 81/2 × 14, 81/2 × 13, 81/2 × 11, 81/4 × 13, 8 × 13, 71/4 × 101/2, 51/2× 81/2, 8K, 16K
You cannot use the following copy paper with this function:
Paper smaller than A5, 51/2 × 81/2
Translucent paper
Label paper (adhesive labels)
OHP transparencies
Postcards
Tab stock
When an odd number of originals are placed in the ADF, the back of the last page of copied paper is blank.
During copying, the image is shifted to allow for the binding margin.
Front and back image quality of copies may differ.
