visable.png

Skip header
 

Erase Outside

Use this function to copy the original while erasing outside of a specified area.

Illustration of Erase Outside

To specify the area you want to erase, you have to define the value of X1, Y1, X2, and Y2 on the original. Measure the area you want to specify before entering the area settings.

Illustration of Erase Outside

X1, X2: 0 - 432 mm (0 - 17 inches)

Y1, Y2: 0 - 432 mm (0 - 17 inches)

1Specify the point where the machine starts scanning (X1, Y1) and where it stops scanning (X2, Y2).

2Press [Edit / Stamp].

Operation panel screen illustration

3Press [Erase].

4Press [Erase Outside].

5Enter the length of [X1] with the number keys, and then press [Sharp].

Operation panel screen illustration

6Enter the length of [Y1] with the number keys, and then press [Sharp].

7Enter the length of [X2] with the number keys, and then press [Sharp].

8Enter the length of [Y2] with the number keys, and then press [Sharp].

If you want to erase the image on the back side of the original, press [2 Sided Setting] and then [Back].

Erasing the image on the back side is valid when you copy 2-Sided originals.

9Press [OK] twice.

Note

  • To change the value you entered, press the key you want to change, and then enter a new value.